Correct hooping techniques might just be the key aspect for producing a quality embroidery designs project. When I bought my first embroidery machine I’d not a clue the way to hoop correctly. In those days there was not a lot of information on the internet. I am one of those those who is not really likely to read a manual unless I encountered problems, Nonetheless I’ve just read the guide for my original embroidery machine and the directions for hooping are vague to say the least.

Proper hooping can look quite time consuming firstly, however practice you are going to turn into very quick at getting your item in the hoop and producing outstanding embroidery.

Firstly try to judge how tight your hoop ought to be to fit your project; you’re going to get far better at this with practice. Now cut a piece of stabelizer bigger than the embroidery hoop, lay this on the lower hoop, now lay the item you want to embroidery over the stabelizer. Sometimes you may need a couple of layers of stabelizer. Ensure that the fabric is nice and straight and even but don’t stretch it. Place the upper hoop over the top and push it into place. this could require a little pressure. Don’t pull the fabric once it is in the hoop this may distort the fabric and affect the placement of your design, additionally it is preferable to not tighten the screws once the project is in the hoop as this can pinch the fabric. If it is not correctly adjusted remove the project and start again.

When the project is hooped appropriately you should be able to run your finger on the fabric without it shifting or rippling, conversely if you have hooped it to tight it can “damage” the fabric, this can not be repaired. Should you have not hooped correctly it may poor registration when stitching. You might end up with your design in one place and the outline elsewhere completely. A very good digitizer will make sure the stitching order is appropriate so that outlines end up where they ought to be however , if bad hooping may cause a fantastic embroidery designs to appear a mess.

When embroidering onto a garment that requires the hoop and stabelizer to be placed within the garment, like a tee-shirt or leg of jeans, a great tip is to use some masking tape to secure the stabelizer on the underside of the hoop. This can just pop off when you push the upper hoop into place but you will save precious time having to chase the stabelizer around in the garment.

Categories : Lora's Posts